Abstract:
Bu çalışmada, dental köprü uygulamalarında metal altyapı ve porselen üst yapı arasında bağlayıcı eleman olarak kullanılan farklı opak malzemelerinin, fırınlama sonrası oluşan ısıl gerilmeler üzerindeki etkileri araştırılmıştır. Çalışmada öncelikle dental laboratuarda dört üyeli, CoCr alt destek yapısına sahip köprü hazırlanmıştır. Hazırlanan bu köprü okulumuz bünyesindeki mekanik laboratuarında bulunan özel dental fırında 9600C sıcaklığına kadar standart fırınlama işlemine tabi tutulmuş, fırının kapağı kademeli bir şekilde açılarak ortam sıcaklığına soğuma gerçekleştirilmiştir. Dental köprünün üzerine çeşitli noktalardan bağlanan termokupllar ile bu noktaların sıcaklıkları çeşitli zaman aralıklarında kaydedilerek, soğuma eğrileri çıkarılmıştır. Bu soğuma eğrileri yardımı ile eşdeğer ısı transfer katsayıları sıcaklığa bağlı olarak hesaplanmıştır. Daha sonra SolidWorks programı ile bu dört üyenin modeli kurulmuş ve model ABAQUS programına aktarılarak analizleri yapılmıştır. Hesaplanan ısı transfer katsayıları, sonlu elemanlar programına girilerek soğuma eğrileri numerik olarak da elde edilmiştir. Deneysel olarak elde edilmiş olan soğuma eğrileri ile sonlu elemanlar programı ile elde edilen eğrilerinin yeterli seviyede birbirlerine yakın oldukları gözlenmiştir. Isıl genleşme katsayıları açısından farklılık gösteren 6 tip opak malzeme aynı modelde tanımlanarak, soğuma sırasında ve sonundaki ısıl gerilmeler birbirleriyle karşılaştırılmıştır. Bu şekilde opak malzemelerin birbirlerine göre üstünlükleri tespit edilmeye çalışılmıştır. In this study it was purposed that to examine the thermal stresses occured after firing process at dental bridge applications in changes of opaque material which is used as binding material between metal substructure and porcelain superstructure. First of all a four unit bridge model has been prepared by a dental laboratory. After that this model has been fired up to 9600C at a special oven which exist at our university's mechanical department's laboratory. At the end of this process, the oven's door was opened in stages to get the model's temperature to ambient temperature. With thermocouples connected to various points on dental bridge, temperatures of these points were saved in various times and we took out the cooling curves. With the help of these cooling curves, we calculated the equivalent heat transfer coefficient according to temperatures. Afterward this four unit's model was built with SolidWorks and this model was imported to ABAQUS then made the analysis . The cooling curves were obtained numericaly by entering the calculated heat transfer coefficients to finite element analysis program. It has been seen that the cooling curves, we got from experimentally and we got from finite element analysis program, came close in enough ratios. Six kinds of opaque materials which shows diversity interms of thermal expansion coefficients were defined in the same model and thermal stresses which occured during cooling and at the end of cooling were compared. With this, we endeavored to fasten down the advantages of opaque materials to each others.